Skip to content

Reiwa Embedded Systems and Electronics

  • Home
  • FPGAs
    • Ultra96-V2 Zynq Ultrascale+ MPSoC Board
    • Kintex-7 KC705 Board
  • Single Board Computers (SBC)
    • Raspberry Pi 4
    • Qualcom DragonBoard
  • Yocto Embedded Linux
  • Electronics and PCBs
  • Projects
  • Blogs

Category: Electronics and PCBs

Home PCB Assembly (Toaster Oven)

by

Objective: This post presents the assembly of Surface Mount Components (SMT) on a 4-layer board using a cheap toaster oven. It aims to show that the toaster is sufficient to achieve remarkable results for DIY PCB boards. Recommended Prerequisite articles to read i) Electronics Work Station: Essential Tools Introduction Some time back, I decided to …

Continue Reading

Testing Custom STM32 Board: Programming

by

Objective: Bringing up a custom STM32 board. This presents the power and programming interfaces required to successfully program a custom board. Recommended prerequisite articles to read: None In this post we test the custom STM32-based Board that was designed and presented in this post. The board is based on the 32 pin STM32F042K6 microcontroller. Power …

Continue Reading

Electronics Work Station: Essential Tools

by

Objective: To present a starter pack for an Electronics work station Recommended prerequisite articles to read: None Background A couple of years back, I was working as a research assistant at a university in Kenya for a renewable energy project. The project was aimed at providing a smart monitoring, billing and control for remote microgrid …

Continue Reading

Recent Posts

  • Home PCB Assembly (Toaster Oven)
  • Dish Antenna Rotator[part 3]: Integration
  • Dish Antenna Rotator [part 2]: Assembly
  • Dish Antenna Rotator [part 1]: Design Concept
  • Ultra96-V2 Zynq UltraScale+ MPSoC Custom Image Build [Part 2]: Petalinux Approach
  • Ultra96-V2 Zynq UltraScale+ MPSoC Custom Image Build [Part 1]: Vivado Hardware Generation
  • Raspberry Pi – Yocto WiFi configuration for automatic connection at boot
  • Custom Raspberry Pi Image Build with Yocto
  • Ultra96-V2 Vivado and Vitis Development Workflow

Archives

  • September 2020 (1)
  • July 2020 (1)
  • April 2020 (2)
  • March 2020 (2)
  • February 2020 (2)
  • January 2020 (1)
  • November 2019 (4)
  • September 2019 (1)
  • May 2019 (1)
© 2021 Reiwa Embedded Systems and Electronics | WordPress Theme by Superbthemes